Shenzhen Jingxinhong Model Co., Ltd.

Large discount!!KDS Flymentor 3D Heli Balancer for RC Heli+PPC

Large discount!!KDS Flymentor 3D Heli Balancer for RC Heli+PPC
Product Detailed

KDS Flymentor 3D Heli Balancer&PPC
KDS Flymentor 3D Heli Balancer
PPC

 KDS Flymentor With this PPC,you don't need carrying the laptop when flying outside!!  ATTENTION:

It is very easy to configure and use Flymentor 3D, but if you are a beginner, it is recommended to find an experienced pilot for help because of the complex adjusting of mechanism.

During adjusting, please be careful about following:

It is recommended to make electronic connection between tail pipe, motor shell and helicopter base for earth connection. If the tail drive structure is belt, you should pay more attention to this issure. Attrition between belt and metal will get static electricity, and it will disturb other electronic devives of helicopter. Confirm all parts of Flymentor 3D have been mounted on helicopter firmly, and the lens of CCD can see the ground, and you should keep the lens clean. The sensor of Flymentor 3D must be mounted horizontally. The Flymentor should keep away from engine and vent-pipe, because the vibration of engine will disturb the working of Flymentor 3D, and the smoke from vent-pipe will cover lens of CCD. You may add magentic ring on wires between controller, sensor and CCD to reduce electronic disturbance. The wire should twist magnetic ring for three circles at least. Channels of aileron, elevator and pitch must be connected with receiver. Connections of gear and aux is optional. Wires which are unused should be locked to prevent unexpected affection. Slot of controller which is unused should be covered to prevent oil stain or oxidation. The maximum turning speed should not exceed 360/s, otherwise the Flymentor 3D may work abnormally.

DESCRIPTION:

 

This is the KDS Flymentor 3D

Here are some highlight features of the KDS Flymentor 3D

Control all movement. including attitde stabilization, speed control, position locking. CCD sensor to capture picture of ground, comparing pictures to avoid drifting. Switch working mode (horizontal mode and position mode) through AUX channel. Integrating head locking gyro and swashplate mizer. Control sensitivity 3S 120, 3S 140, 4S 90, 4S 90+45. Keep balance in inverted flight. Configured by computer through USB. If you are using FM/PPM remote control device, when helicopter is out of control, the Flymentor 3D will set aileron, elevator, rudder to neutral, and keep pitch in the final signal position, and switch to positioning mode automatically, the sensitivity is 70%.


The Flymentor 3D is consist of three modules, Controller, Sensor and CCD.


Configuring Flymentor 3D must use a computer, you should take a computer with USD port and mouse, and it must has Microsoft Windows OS (Windows XP / Vista / 2000).


The Using flow of Flymentor 3D. You can divide them into two stages, Mounting stage and Flying adjustment stage.

SPECIFICATION:

Voltage: 4.8 - 6.0V Current: 55mA (under 5V) Weight: 37g

ITEM INCLUDED:

1 x KDS Flymentor 3D Set1 x KDS Flymentor PPC

 

 

 

 

 



Copyright Notice @ 2008-2022 B2BAGE Limited and/or its subsidiaries and licensors. All rights reserved.